Baumatic BTI970SS User Manual

1BTI970SS 90 cm Island cooker hood in stainless steel

o There are several buttons on the control panel, which perform separate functions. = Off button 10 = Low speed = Medium speed = High spe

11o If you are using the appliance in recirculation mode, then be sure to replace the carbon filters at the recommended interval (see section on “Fi

Maintenance Removing and cleaning the grease filters o First remove the grease filters by pulling down on the handle and pulling them away from th

Changing a light bulb IMPORTANT: BEFORE ATTEMPTING TO CHANGE A LIGHT BULB, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR MAIN

Fitting the carbon filters If the appliance is being used to be used in recirculation mode then it is necessary to fit carbon filters. This will help

Installation IMPORTANT: Before installation and usage read all the instructions and make sure that the voltage (V) and the frequency (Hz) indicated o

o As the colours of the wires in the appliance’s mains lead may not correspond with the coloured markings identifying the terminals in your spur box,

o Remove any protective wrapping that has been put on the cooker hood or chimney sections, to protect them during transit. Positioning

IMPORTANT: Although the minimum height of the appliance can be set at 748 mm. During the installation process you will need to move the lower chimney

Supplied installation components 1) Position the hanging plate on the ceiling and then mark the position of the screw holes. o The hanging plate

User Manual for your Baumatic BTI970SS Cooker Hood 90 cm Island cooker hood in stainless steel NOTE: This User Instruc

2) Fix the angle bars to the hanging plate, using the 8 x M4 nuts and bolts with metal washers. 3) Extend the angle bars to the required

5) If you are going to be using the hood in extraction mode, you should fit the spigot for the duct hose onto the main body of the cooker hood, usin

22o If you are using the appliance in recirculation mode, then you should now fit the carbon filter. See the “Fitting the carbon filters” section on

Troubleshooting IMPORTANT: If your cooker hood appears not to be operating properly, before contacting Baumatic Customer Care, please refer to the ch

IMPORTANT: If your appliance appears not to be operating correctly, then you should disconnect it from your mains supply and then contact the Customer

25 United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 6900 Sales

26

27

28

3Contents Page Environmental note 4 IMPORTANT SAFETY INFORMATION 5 – 7 Specifications of your cooker hood 8 – 9 Using your Ba

ENVIRONMENTAL NOTE Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useles

IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before att

o The edges of the cooker hood are sharp – be mindful of this as you handle your appliance, especially during installation and cleaning. DO NOT CLEAN

o Remember that when in extraction mode, your cooker hood is removing air from your room. Ensure that proper ventilation measures are being observed

Specifications of your cooker hood Congratulations on purchasing a Baumatic cooker hood! PRODUCT DIMENSIONS Height: 748 mm * – 1248 mm ** Widt

** IMPORTANT: Please see the positioning instructions on pages 17 - 18 to obtain precise information on the height requirements for this product. Usi