Baumatic BWD12.1 User Manual Page 1

Is BWD12.1 Fully integrated washer dryer

LCD display 1. Wash program phases: o Prewash o Wash o Rinse o Spin and drain o Drying 2. Spin speed. 3. Program number (for

Detergent drawer Pre wash section This compartment should have detergent placed in, if you are going to select a wash program that has

Preparing the wash cycle Preparing your garments for washing o Your washing should be sorted out, according to the fabric type and the wash care sy

A selection of wash care symbols o The wash care symbols should be used to help you to select the most suitable wash program. They will also help

Detergents and conditioners The amount of detergent that you need to use in your appliance, will depend on o The degree of soiling. Lightly soiled

1515

16NOTE: the KWh and litre consumptions and program durations may vary depending on the type and amount of clothes being washed, your mains water pres

Selecting a wash program 9 Load your laundry and put detergent in the relevant compartment of the soap drawer. 9 Close the porthole door firmly.

o The active phases will appear at the top of the display, as the wash program progresses. The time remaining until the end of the program will updat

Selecting an automatic wash and dry program 9 Activate the pop out program selector knob by depressing it. 9 Select the most appropriate wash prog

USER MANUAL FOR YOUR BAUMATIC BWD12.1 Fully integrated washer dryer NOTE: This User Instruction Manual contains important

o It is also possible to put the machine into PAUSE status by pressing the START/STOP button whilst the wash cycle is in progress. However this will

9 Press the spin selection button and the spin speed will reduce in 100 rpm increments. o It is possible to reduce the spin speed from th

9 If you want the appliance to drain only, press the spin reduction button until the symbol appears in the LCD display, then press the START/STOP b

o The program option button needs to be pressed after a wash program has been selected, but before the wash program has been started. If you select a

o If you want to cancel the child lock option before the wash program completes. You should hold down the START/STOP button for at least t

Detergent drawer Occasionally the detergent drawer should be cleaned. o Pull the detergent drawer out as far as it will go and then remove the dra

26Door gasket 9 You should regularly check to see if any deposits have formed, or there are any foreign bodies in the rubber door gasket. This sits

If a fault code reappears after following the above advice and clearing the fault code. You should turn the wash program selection knob to the off pos

IMPORTANT: Your appliance has an unbalance control system. If this system detects that the washload is unevenly distributed inside the drum. Your wash

There is white residue on my garments when I remove them from the appliance. o Modern detergents can contain insoluble contents, and white re

3Contents Environmental note 4 Important safety information 5 - 6 Specifications 7 Description of the appliance 8 Control p

Turn the filter a quarter turn anti clockwise, water will start to come out of the drain pump. Continue to turn the filter anti clockwise until you re

Installation IMPORTANT: THIS INSTALLATION MUST BE COMPLETED BY A SUITABLY QUALIFIED PERSON. BAUMATIC ONLY SANCTION THE INSTALLATION GIVEN IN THIS INST

32 9 Using a screwdriver, refit the three plastic transit bolt covers that you removed previously. IMPORTANT: The transit bolts MUST be re

9 Once levelled correctly, you should tighten the lock nut back up on each of the washing machine feet using a spanner. IMPORTANT: When the w

9 IMPORTANT: There should be a filter sitting inside the end of the inlet hose that connects to your mains water supply. The inlet hose may leak if t

Power supply 9 IMPORTANT: As your appliance is a built in product, the electrical socket must still be accessible once the appliance is installed.

Before first use maintenance wash o When your washing machine has been correctly installed, we recommend that you perform a maintenance wash cycle.

37 United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 690

38

39

ENVIRONMENTAL NOTE Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useles

40 40

IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before atte

6o Before the first use of the appliance, we advise that a 90 degree cotton wash is completed. No garments should be placed inside the machine; howe

Specifications 9 13 wash programs/2 drying programs 9 6kg wash load/3kg drying load 9 1100 rpm maximum spin speed 9 LCD display 9 Delay sta

Description of the appliance 8

Control panel Wash program selection knob This control knob allows you to select the wash program of your choice. To activate it you should press i