Baumatic BDW13 User Manual

77 BDW13 60 cm Fully integrated full height dishwasher

Control panel 1) Program indicator neons 2) Program selection button 3) Rinse aid and salt indicator neons 4) ½ load indicator neon 5) ½ loa

Filling with dishwasher salt IMPORTANT: You should only use salt that is specially designed for use in a dishwasher. If any other type of salt is use

o IMPORTANT: You do not need to pour 1 litre of water into the container when you subsequently fill the water softener with salt. Setting the water

Filling with rinse aid The rinse aid is released during the final rinse and it helps to prevent water from forming droplets on your dishes. These dro

o You should continue to adjust the rinse aid level upwards until you get no water spots. o If you get cloudiness or streaking on your dishes, the

Loading the upper basket The upper basket is most suited to washing delicate and light dishware, such as glasses, coffee & tea cups, saucers, pla

Lower position o If the upper wheels are placed in the guide supports, then the basket is in the lower position. o For accommodating additiona

IMPORTANT: Care should be taken to make sure that the spray arms can move freely when items have been loaded into the baskets. Loading the lower bask

o For the best washing performance, cutlery should be placed through the slots in the top of the cutlery basket. IMPORTANT: Do not allow items of cu

The following items are NOT suitable for washing inside a dishwasher:- o Cutlery with a handle of mother-of-pearl, wood, horn or china. o Plasti

USER MANUAL FOR YOUR BAUMATIC BDW13 60 cm Fully integrated full height dishwasher NOTE: This User Instruction Manual contai

Program table Program Cycle Program information Description of cycle Detergent pre/main Normal * For normally soiled loads, such as pots, plates, g

21o Push the top and bottom baskets fully back into position. o Add detergent o Turn the appliance on by using the ON/OFF button. o IMPORTANT:

22At the end of a wash program o The time display will flash for 8 seconds and a buzzer will sound. o If you have used the delay start mode, the

Setting a half load The half load option means that the lower spray arm does not run. IMPORTANT: You should only load items in the upper basket when

o The neon indicates that you need to add dishwasher salt to the appliance. You should follow the procedure outlined on page 11. Cleaning and main

Cleaning the filters For best performance and results, the entire filter assembly should be thoroughly cleaned regularly (ideally after each wash cyc

Cleaning the spray arms The spray arms should be cleaned regularly, to prevent hard water deposits from clogging the spray arm jets a

Cleaning the door o To clean the edge around the outside of the door, you should use a soft, damp cloth only. o To prevent water from penetr

28E3 o Longer heating time- not reaching the required temperature. 9 Malfunction of the temperature sensor or heating element. 9 Call Baumatic Ser

IMPORTANT: If any other fault code appears in the display window, you should not attempt to clear it yourself and contact the Baumatic Service Departm

3Contents Environmental note 4 Important safety information 5 – 7 Specifications 8 - 9 Description of the appliance 9 - 1

30Utensils are not secure in the baskets or something small has dropped into the basket Motor hums Ensure that everything is loaded as per Baumatic’

Dishwasher leaks The rinse aid dispenser is overfilled or rinse aid has been spilt inside the appliance Dishwasher isn’t level Take care not to over

32o The aperture that your dishwasher needs to be installed into should resemble the one shown in the drawing on page 31. o There should be less t

33o The maximum weight of the furniture door should be 5.5 kilograms. The maximum thickness of the furniture door should be 15 mm. o Use the insta

34Adjus door spring o The door of the dishwasher is attached to springs. These are set at the factory to ensure that they are at the proper tensio

35Co IMPORTANT: Do not connect the appliance to your mains water inlet hose. The inlet hose supplied with the dishwasher is the ONLY one DO NOT CONNE

36onnecting to the water outlet 9 Secure the drain hose, so that it cannot move whilst the dishwasher is in use. 9 Place the end of the drain hos

37 9 rating plate, located on the right hand side of the drop down door BEFORE making the electrical connections. g the plug is the same as

38r dishwasher. o Ensure that the underneath of the worktop is clean before o Separate the backing paper away from the strip. o o IMPORTANT: F

39Levelling the appliance o IMPORTANT: Your dishwasher must be level for it to operate properly. o Make sure that the dishwasher is supported wh

ENVIRONMENTAL NOTE Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useles

40Securing the dishwasher o The dishwasher must be secured to the odone in one of two ways:- o Standard worktop- Secure the dishwasher to the un

41 United KingBaumatic Ltdaumatic Buildings, 6 Bennet Reading, rRG2 0QX nited KingdSales Te dom ., BRoad, Be kshire om U lephone 900 (0118) 933

42

43

44

IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before atte

6o Care should be taken not to trap the power supply cable underneath the appliance whilst installing it. o No attempt should be made to alter or

7Child Safety o Your dishwasher should only be used by adults. You should not allow children in the area of the machine unsupervised. You should no

8Specifications Product dimensions Height: 820 - 850 mm Width: 595 mm Depth: 540 mm Aperture dimensions Height: 820 mm (min) Width: 600 mm Dept

Electrical details Rated voltage: 230 Vac 50 Hz Supply connection: 13 A (double pole switched fused outlet with 3 mm contact gap) Optiona