s TITAN2 Stainless steel side by side frost free fridge/freezer
10Salad/vegetable drawer o For storing salad and vegetables, the drawer is designed to keep the contents fresh for as long as possible. Fruit draw
Using your Baumatic fridge freezer Before switching on o Make sure that it has been installed by a suitably qualified person, as per the informatio
Control panel The control panel is located in the front of the freezer door, above the dispenser. This should always be displayed when the a
Turning on the appliance o You switch on your appliance by connecting it to your mains supply. Setting the thermostat in the freezer o Press the
o The temperature shown in the display will count through in the sequence shown below:- o We would recommend that the fridge section is set to a m
Turning on the super refrigerator option This setting should be used if you want to chill something quickly, it will ensure that a powerful supply of
16o Make sure that you arrange food in such a way that the door can close completely. Particular attention should be given to bottles that may protr
The freezer compartment The freezer compartment is suitable for storing and freezing food. o The freezer compartment temperature must have alread
Tips on freezing o Freezer bags, polythene wraps, aluminium foil (extra thick) and special cans for frozen foods are suitable packaging for storing
The dispenser When your fridge/freezer is first connected to your mains supply, it will automatically select chilled water mode and the water symbol
USER MANUAL FOR YOUR BAUMATIC TITAN2 Stainless steel side by side 541 litre frost free fridge/freezer NOTE: This User Inst
20o Place a cup against the pad in the dispenser and push it, after a few seconds it will dispense water, cubed ice or crushed ice. What comes out o
Dispenser and ice maker warnings o Avoid using fragile cups or crystal glasses if you are dispensing cubed or crushed ice, as damage could be caused
Removing and replacing the ice cube storage case o Pull the storage case forwards to remove it from the freezer. o To put the storage case back i
Cleaning and maintenance 23WARNING: PLEASE ENSURE THAT YOUR APPLIANCE IS DISCONNECTED FROM YOUR MAINS SUPPLY BEFORE ATTEMPTING TO CLEAN IT. o Do
Fridge and freezer door compartments 1) To remove a fridge or freezer door compartment, hold both ends and pull upwards. Fridge and
Dispenser shelf 1) Take out the spillage grill and use a cloth to remove water from and clean this area. DO NOT USE ANY FORM OF ASOLI
o IMPORTANT: You should place some old towels on the flooring that is immediately in front of the appliance. In case any defrost water comes out of t
3) Change the present light bulb with a new one. The replacement bulb should not have a greater rating than 15 W. 4) Push the cover ba
Installation IMPORTANT: Before installation and usage read all the instructions and make sure that the voltage (V) and the frequency (Hz) indicated on
29Positioning o It is advisable that your appliance is only installed in a location where the ambient temperature of the room, corresponds with the
Contents Environmental note 4 Important safety information 5 – 6 Specifications of your fridge freezer 7 Dimensions of the applia
Installation preparation IMPORTANT: A minimum of two people should complete all of the installation steps given in this manual. o Check that the
3) Turn the top hinge fastener anti-clockwise 3-4 times and then disconnect the harness wires. 4) IMPORTANT: One person should
Removing the fridge door 1) Unscrew the top hinge cover using a screwdriver. Insert a thin screwdriver into the side groove of the cover
Replacing the freezer door 1) Firstly insert the water tube into the hole in the bottom hinge and then insert the bottom of the freezer door
5) Push down the left hand collar of the coupling and then insert the water tube as far as it will go into the coupling. When it is securely i
4) Place the top hinge cover back into position and using a screwdriver, fully tighten it to the top of the cabinet. The water inlet hose and
o On the position that you have marked, cut the inlet hose off vertically. o Connect the inlet hose to either side of the water filt
4) Screw and fasten the filter holder to the left or right hand side of the rear of the appliance. o If the filter holder does not attach very well
o When you are confident that there are no bends in the water inlet or no leaks, replace the rear cover. You should make sure that the water inlet si
Levelling the appliance and adjusting the doors The appliance must be situated on a level and even floor; otherwise the doors may not hang properly o
Environmental note Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useles
Replacing the water filter o IMPORTANT: Before commencing this process, please disconnect your appliance from the mains and turn off the water tap.
My fridge freezer is noisy o The refrigerant gas that circulates the pipework of the appliance may make a slight noise, even if the compressor is
42Baumatic Ltd. Conditions of guarantee Dear Customer, Your new Baumatic appliance comes complete with a free 12 month guarantee covering both part
43 Headquarters Baumatic Ltd. Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX, United Kingdom Sales Telephone +44 118 933 6900
44 44
Important safety information Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before atte
Child safety o Packaging material should be kept away from children. o Children should not be allowed to touch the controls or play with the appli
7Specifications of your fridge freezer Congratulations on purchasing a Baumatic fridge freezer Dimensions of your appliance o Height: 1790 mm
Description of the appliance Freezer section 1) Door storage compartments 2) Freezer shelves (x 4) 3) Dried foods compar
9Description of the product features Shelves o The shelves may be placed in any of the guide slots within the interior of the appliance. They are
Comments to this Manuals