BAUMATIC BDW13, BDW14 dishwasher user manual
19
19
BEFORE YOU CALL FOR SERVICE …
CHECKING AGAINST THE CHARTS BELOW MAY FIX YOUR PROBLEM.
PROBLEM POSSIBLE CAUSES WHAT TO DO
• Fuse blown, or the
circuit breaker acted
• Replace fuse or reset circuit
breaker.
• Remove any other appliances
feeding from the same socket as
the dishwasher.
• Power supply is not
turned on
• Make sure the dishwasher is turned
on and the door is closed securely.
• Water pressure is low
• Check that the water supply is
connected properly and the water is
turned on.
Dishwasher
doesn’t run!
• … And (situation A)
the number 17 is
showing on the
display. This means
that your dishwasher
has entered Test
Mode – a factory
sequence which you
need not concern
yourself with. This
happens because the
Delay Timer key was
pressed before the
‘ON/OFF’ key was
pressed.
• … Or (situation B)
the display shows one
of the following: 0A,
09, 08, 07, 06, 05,
04, 03, 02, 01, 00.
• For situation A, Press and hold
down the Delay Timer key at the
same time as you’re pressing the
‘ON/OFF’ button to switch the
dishwasher off. Wait a few
seconds then press only the
‘ON/OFF’ button again. You are
now ready to program your
dishwasher for a washing cycle as
per usual.
• For situation B, Press ‘ON / OFF’
button to turn the dishwasher off.
Then, press and hold down the
Program Key (‘P’) at the same
time as you’re pressing the ‘ON /
OFF’ button to switch the
dishwasher on again. You are now
ready to program a cycle as per
usual.
Drain Pump
doesn’t stop!
• Overflow
• The system is designed to detect an
overflow. When it does, it shuts off
the circulation pump and turns on
the drain pump. Call a Baumatic
Ltd approved technician.
Comments to this Manuals